EZ-Flash USA Forum

Can somebody extract firm of file NDS?
I need the file .bin to directly program the chip (M25P04) of EZ-Flash Vi (white).
Thanks.
http://www.ezflash.cn/zip/ez5firmwareV15.rar

Why do you need that ?

There is an unbricker available if you need to unbrick your ez5i (see the stickied post).

Bricker full.
I used ez5iunbricker1.01 and ez5unbricker_V2.0 without success.
And with one Willem Programmer can to recover.
Excuse me my english.
I will put images.

If the unbricker is unable to unbrick your ez5i, flash the binary in the flash memory won't help at all.
You need a FPGA programmer and the AES crypted firmware for the xilinx.
Dead end for you, sorry.

Only need the firm M25P04 of the EZ-Flash Vi White.

No, you don't need that. You need the internal firmware of the xilinx. There is 2 updatable memories on the ez5i, the FPGA component and the flash memory M25P04.
If you bricked the ez5i while it was updating the xilinx's internal memory, your EZ5i is definitively a brick.

The unbricker is able to talk to the M25P04 if the FPGA is able to start. Bad xilinx's firmware require to flash again this component.
it's a dead end as i said.

BTW, be sure to have read my thread here about the unbricker : viewtopic.php?p=74383#p74383
Also, be sure to use a ds or dslite to try to unbrick it. It's the only console that allow hot swap in the slot 1.