EZ-Flash USA Forum

I'm running EZ3Check to try and figure out why I can't do anything with my EZ-Flash III card.

However, I *think* I'm having a problem here, but I'm not exactly sure. This is what EZ3Check is reporting to me:

Starting Erase EZ3
-1- starting Erase 32M Loader
Chip ID[0x0020001c]
Erasing sector 0
-2- Starting Erase 256M NORFlash
Chip ID[0x7e027e02]
starting erasing sector 0
-3- starting Erase NAND Flash
chip ID[0x1580dcad]
NAND FLASH ID Error
*****over*****

Is this normal? If so, then what in the heck do I need to do next to get my EZ-Flash III card to run DS Games? I can't even get EZ3Manager to start without crashing now.

Use EZManager 2.20 to format the NAND with since it has an updated routine to mark areas of the NAND bad. Hopefully that will solve any problem it has. Have you had any problems with the NAND? Why did you run EZCheck?

I ran EZCheck because I haven't been able to run a single game (GBA or NDS) on my EZ-Flash III card since I obtained it. I've read everything I can get my hands on about the flash card and EZManager but I can't get it to work. The closest I get is to load a game (GBA or NDS) onto the flash card, but it always either hangs or gives me a while/black screen and does nothing else every time I try to play a game. What could I be doing wrong?

Try cleaning the pins on your EZ3 with an erase or qtip with alcohol. If games still hang and you still have problems I'd contact the seller for a replacement.